Supported Platforms:
* Arduino
* Raspberry Pi
* ESP-8266
Features:
Moisture Sensor Comparator Board (based on LM393)
Easy to Use
Detect soil moisture being capacitance sensor
Analog and Digital output
Operating voltage: 3.3V~5V
Included Jumper Wires
LED Indicators
Digital High/Low Output
Nickel Plated Anti-Rust Spade
Wide Sensor Area
M2.5 Mounting Holes
Spade Dimensions: 65mm x 25mm
Comparator Board Dimensions: 36mm x 21mm
Never fear the knights that say Ni again! Use this soil moisture sensor to complete your project or to keep your houseplants and various bits of shrubbery in tip-top condition!
The moisture sensor board features both analogue and digital outputs. The analogue output gives a variable voltage reading that allows you to estimate the moisture content of the soil (using some math!). The digital output gives you a simple "on" or "off" when the soil moisture content is above a certain value. The value can be set or calibrated using the adjustable on board potentiometer.
The sensor features a nickel plated anti-rust spade, and a wide sensor to ensure accurate moisture readings. The module uses the LM393 "comparator" chip-set to measure the moisture content.
No Document Available.
