Monster Motor Driver

30A Monster Moto Shield VNH2SP30 stepper motor driver module 30A for Arduino
Availability :    Out Of Stock

Enter mobile number to get notification when available

৳1543.72 ৳1743.72
Quantity :

Monster Motor Driver  Specification

30A Monster Moto Shield VNH2SP30 stepper motor driver module 30A for Arduino.

  • Maximum input voltage: 16V
  • Peak drive current: 30A
  • Sustainable start current: 14A
  • Maximum PMW frequency: 20 kHz
  • The output impedance is only 19m
  • Current can be detected by Arduino analog input pin
  • With over temperature protection, over voltage and under voltage protection.
High current 30A VNH2SP30 stepper motor drive module High current 30A stepper motor drive. This is a module designed for high-horsepower motor drive. The powerful performance of the module makes it only need a pair of VNH2SP30 to replace the L298 H- bridge to provide full-bridge motor drive. At the same time, we have strengthened the load capacity of the circuit to drive it. A pair of high current motors! Both the input end of the module and the motor interface end use 5mm interface terminals, making it convenient to connect large-size wires. When ultra-high current is required, the wires can be directly welded to the module instead of connecting with terminal blocks (as the case may be). When the drive current is greater than 6A , the chip will heat up. In order to improve performance, it is best to connect a heat sink or cooling fan.

No Document Available.

Our Brands